Pentium® II-Klamath (socket 1)

Pentium® II-Klamath (socket 1) - CPU Connector

Microprocessor Removal Type 6588, 6888

Remove Airflow Cover.
Push in the two Tabs, until Tabs release.
Carefully place one hand on the system board and pull the microprocessor up and out of the connector with the other hand.

When replacing the system board, keep the following:

Retention Bracket
System Board Plate
Screws and Washers

Make sure the plastic washers are attached to the six mounting tabs of the system board plate, and that the washers are under the two front screw heads that secure the system board plate.

If any of the washers are not installed (as shown), the system board can be damaged.