Service Processor Requirements

Service Processor Requirements

The service processor (SP) follows the following rules for each power-on and -off cycle.
The following functions are complete at power-up. (See also 'Starting or Stopping the System')

Because the SP runs continuosly in this version, an internal interrupt is generated each time the Start/Stop button is pressed. This interrupt will set the Power-State bit in the RTC's SRAM and set the PAB bit to zero (0) turning on the power supply.
At SP power-on, the RTC's Power-State bit is checked to determine if the system should stay powered-on after an AC power failure.

Please see the LEGAL - Trademark notice.
Feel free - send a

for any BUG on this page found - Thank you.