How to Run the Loop Test (3546)

How to Run the Loop Test

  1.  Go to the advanced diagnostic screen by  pressing Ctrl+A on the basic diagnostic screen.
  2.  Select the Looptest icon and press Enter  or click the click button.
  3.  Select a device and press the Spacebar. A OK mark  appears for the selected device.
  4.  If the selection is OK, select OK and press Enter to start the loop test.
  5.  To exit the loop test, press and hold Ctrl+Pause  until the interrupt is accepted by the test program.  A beep sounds when the interrupt is accepted.  The test loop stops at the end of the current test.

Please see the LEGAL  -  Trademark notice.
Feel free - send a Email-NOTE  for any BUG on this page found - Thank you.