Power-on Password (8551)



  Power-on Password

To service a computer with an active, unknown, power-on password, do the following.
  1.  Power-off the computer and unplug the power cord.
  2.  Remove the bottom cover and the battery pack.
  3.  Locate the override connector on the system board.
  4.  Install a jumper over the pins as shown.
  5.  Power-on the computer to erase the password.
  6.  After POST completes, remove  the jumper. Otherwise, you will  not be able to reset a power-on password.

 

To reactivate the password, start the system programs, select Set features from the Main Menu, then select Set password and unattended start mode, and follow the instructions on the screen.

Please see the LEGAL  -  Trademark notice.
Feel free - send a Email-NOTE  for any BUG on this page found - Thank you.