| Error Code | FRU/Action |
|---|---|
| Internal SCSI hard drive | 1. Run Setup/Configuration Utility. |
| does not configure on boot | 2. Run SCSI Select Utility. |
| 3. Suspect FRUs in the following order: | |
| a. SCSI cable | |
| b. Media Power cable | |
| c. Hard file | |
| d. I/O Function card | |
| e. SCSI backplane | |
| External SCSI device does | 1. External SCSI devices must be powered-on before |
| not configure on boot | you power-on the server. |
| One or more of the following | 2. The cables for all external SCSI devices are connected |
| might be causing the problem: | correctly, and are not damaged. |
| 3. If you have attached an external SCSI device to the server, | |
| make sure the external SCSI termination is set to automatic. | |
| 4. The last device in each SCSI chain is terminated correctly. | |
| 5. The SCSI devices are configured correctly. | |
| 6. Front Panel Cable. | |
| Internal SCSI device | 1. SCSI device (if in a RAID configuration) |
| status LED stays lit | 2. SCSI backplane |
| constantly | 3. SCSI cable |
| Negotiation failed | 1. Swap the SCSI cable on the I/O function card |
| to the other SCSI port and reboot system. | |
| If the failure is the same as before, suspect FRUs | |
| in the following order: | |
| a. DASD drive | |
| b. SCSI cable | |
| c. SCSI backplane | |
| 2. If the system does not fail with the SCSI cable | |
| plugged into the other SCSI port, replace the | |
| I/O function card. | |
| Wide negotiation failed | 1. Swap the SCSI cable on the I/O function card to |
| the other SCSI port and reboot system. | |
| If the failure is the same as before, suspect FRUs | |
| in the following order: | |
| a. DASD drive | |
| b. SCSI cable | |
| c. SCSI backplane | |
| 2. If the system does not fail with the SCSI cable | |
| plugged into the other SCSI port, replace the | |
| I/O function card. | |
| Termination error or faulty | 1. Swap the SCSI cable on the I/O function |
| cable | card to the other SCSI port and reboot system. |
| If the failure is the same as before, suspect FRUs | |
| in the following order: | |
| a. DASD drive | |
| b. SCSI cable | |
| c. SCSI backplane | |
| 2. If the system does not fail with the SCSI cable | |
| plugged into the other SCSI port, replace the | |
| I/O function card. |
Please see the LEGAL - Trademark notice.
Feel free - send a
for any BUG on this page found - Thank you.