Appendix B. Updating the Tape Library Firmware on the RS/6000
This appendix presents the steps required to update the tape library firmware using
the Atape tapeutil tool available on RS/6000 computers.
This tool downloads the firmware from a file or diskette across the SCSI bus to the tape library controller.
The file must be a binary file (*.bin). The tape library must be in the on-line mode.
Note: The Atape device driver must be at level 3.2.0.6 or higher
(see 'Installing the Device Driver (for RS/6000 Users Only)').
Two methods are described: