Power Cables


Power Cables

The tape library power connector is located on the back panel at the rear of the tape library (see Figure 3).

  1.  Make sure that the tape library is turned off (press the 0 on the ON/OFF switch).
  2.  Connect the power cable to the power supply in the tape library.
  3.  Connect the other end of the power cable to a power source.


The tape library can now be powered on and operated.
The tape library comes preset with SCSI addresses and operating configurations that meet most users requirements.
If, however, you need to change any settings, refer to 'Setup Procedure'.

Please see the LEGAL  -  Trademark notice.
Feel free - send a Email-NOTE  for any BUG on this page found - Thank you.