Removing and Replacing the Power Supply

Removing and Replacing the Power Supply

This procedure describes how to remove and replace the power supply.
Below figure 39 shows an exploded view of the components for removing or replacing a power supply.

1.  Turn oft the power to the tape library by setting the power switch to off.
2.  Disconnect the power cord from the power supply.
3.  Remove the four screws securing the power supply to the tape library back panel.
4.  Remove the power supply by grasping the handle and pulling back until the module is free from the tape library.
5.  Replace the power supply by aligning the edges of the power supply slide in the guides and pushing the  power supply into the tape library until the female connector on the power supply completely engages the  male connector in the tape library.

    The connectors are completely engaged when the power supply is flush with the tape library back panel.

6.  Reinstall the four screws securing the power supply to the tape library back panel.
7.  Reconnect the power cord to the power supply.
8.  Turn on the power to the tape library by setting the power switch to on.