Removal and Replacement Procedures

  Chapter 4. Removal and Replacement Procedures


This chapter explains how to remove and replace the following field replaceable units (FRUs):

•  Removing and Replacing a Tape Drive
•  Installing a Second Tape Drive

•  Removing and Replacing the Controller
•  Removing and Replacing the Power Supply
•  Removing and Replacing the Power Supply Fuse
•  Removing and Replacing the Desktop Tape Library Cover
•  Removing and Replacing the Door Bezel and Upper Bezel
•  Removing and Replacing the LCD Assembly
•  Removing and Replacing the Bar Code Reader

•  Removing and Replacing a Base Tape Library

  -DANGER-


To prevent a possible electrical shock when adding or removing any devices to or from the system, ensure that the power cords for those devices are unplugged before the signal cables are connected or disconnected.
If possible, disconnect all power cords from the existing system before you add or remove a device. (RSFTD2O3) 

Note: This product contains Torx screws. A set of Torx screwdrivers can be obtained by IBM Service Personnel by ordering Chesco 13 Pc Torx Set (IBM part number 62G1347).