Tape Drive SCSI Address Setup

Tape Drive SCSI Address Setup

The tape drives in the tape library come preset to meet most customer needs.
If, however, you need to change a SCSI address, the following explains how to make the change.

The SCSI ID on the tape drives must be changed if you change the tape library controller SCSI ID to one that conflicts with a tape drive. The default SCSI IDs are:

Drive A = 4
Drive B = 5
Library Controller = 6

The SCSI ID on a tape drive can be changed using the push button switch on the drive rear panel (see Figure 3).
The push button switch is integral with the SCSI ID number display.
Press the push button switch to the right or left of the number display to set the tape drive to the desired SCSI ID.

The tape library must be powered off, then on to make the change effective.

Please see the LEGAL - Trademark notice.
Feel free - send a

for any BUG on this page found - Thank you.