Error Symptoms (Netfinity 7000-M10 - Type 8680)

Error Symptoms

Error Symptom	FRU/Action
CD is not working properly.	1. Clean the CD
	2. Clean the optical-head lens.
	3. CD-ROM Drive
CD-ROM drive tray is not working.	1. Insert the end of a paper clip into the manual tray-release
(The server must be powered-on.)	opening.
If the server is on and the tray	2. CD-ROM Drive
does not eject,
CD-ROM drive is not recognized.	1. Run Configuration/Setup, enabled primary IDE channel.
	2. Check cables and jumpers.
	3. Check for correct device driver.
Diskette drive in-use light	1. The diskette drive is enabled in the configuration programs.
stays on, or the system	2. The diskette is good and not damaged.
bypasses the diskette drive.	(Try another diskette if you have one.)
	If there is a diskette in the drive, verify that:
	3. The diskette is inserted correctly in the drive.
	4. The diskette contains the necessary files to start the server.
	5. The software program is OK.
	If the diskette drive in-use light stays on, or the system
	continues to bypass the diskette drive, replace the diskette drive.
Fan (one only) not running.	1. Swap fans to see if the fan is defective.
	2. Power Control Card
	3. Fan Cable
Fans (two only) not running.	1. Check the connection between the fan cables and the power backplane.
	2. Fans
	3. Power Control Card
	4. Power Backplane
Fans (all) not running.	1. Check fan cables
	2. Power Control Card
	3. Power Backplane
Fans (all) continuously run fast.	1. Power Control Card
	2. Front Panel Card
	3. System Management Card
Monitor problems (general)	1. Monitor
Some IBM monitors have	2. Display Adapter/I/O Function Card
their own self-tests. If you	3. I/O Board
suspect a problem with the
monitor, refer to the
information that comes with
the monitor for adjusting
and testing instructions.