Power Control Card Removal (Netfinity 7000-M10 - Type 8680)


Power Control Card Removal

Before you begin: Read 'Safety Information'

The power control card is located in the rear of the system.

 

To remove the power control card, do the following:
  1.  Power-off the system.
  2.  Disconnect all power to the system.
  3.  Remove the power control card screws -1-
  4.  Pull the power control card -2- out of the the system.


Please see the LEGAL  -  Trademark notice.
Feel free - send a Email-NOTE  for any BUG on this page found - Thank you.