EMS Board Replacement - EXP200 Type 3530 - 1RU, 1RX
ESM Board Replacement
To remove the ESM board:
- Shut down the expansion unit.
For shutdown information, see 'Performing a Shutdown'.
- Grasp each pull-ring and squeeze the latches to release.
- Pull open both levers at the same time and remove ESM board.
Note: When inserting the ESM board:
- Make sure both levers are straight out, as shown above.
- Using your hand, gently push on the center of the ESM board to insert it into the controller.
- When inserting the ESM board, make sure both levers swing inward at the same time.
- Close and lock both levers at the same time.
Please see the LEGAL - Trademark notice.
Feel free - send a for any BUG on this page found - Thank you.