Updating the Server Configuration

Updating the Server Configuration

When you start the server for the first time after you add or remove an internal option or an external small computer systems interface (SCSI) device, you might see a message telling you the configuration has changed.
You might need to install device drivers (required only if the option has a device driver).
Refer to the documentation that comes with the option for information about installing any required device drivers.

NOTE:

1.  If you remove the last (terminated) SCSI device from the external SCSI cable connected to the  SCSI connector on the back of the server, the server might not recognize any SCSI devices that  are still connected on that SCSI channel (cable).
2.  When a hard disk drive is added and you want to include it in the startup sequence, use the Start  Options selection of the Configuration/Setup utility programs (see 'Start Options').
3.  When you install an ISA legacy adapter, you must allocate system resources to support it (see 'Plug and Play').
4.  You can find the list of supported hardware and software for the server at

   http://www.pc.ibm.com/compat on the World Wide Web.

What to do next

•  Device drivers to install? See the instructions that come with the option to determine if device  drivers are required, and, if so, how to install them.
•  If you do not need to install any device drivers or update the system configuration, the server is  ready to use.