System Board Type 8639 (FRUs 60H7198 / 11H5545)

NOTE The System Board-type used, depends on Server model. If the J101 (in pos.12) RATIO Jumper is a 2-pos Jumper, this board type does not support 133MHz Pentium® processors.
If someone try to install a 133MHZ processor on such a 2-pin board and maybe it works after removing the jumper in location 12 (J101) then this board/processor will be damaged. When you re-install the old (previously removed) for a lower speed designed processors, then it can happen that this board will not function. (No BEEP - No Display)
Try the following.

Power-Off the system, and remove the (J101) jumper.
Power-On the system for <=45 seconds.
Power-Off the system and place the (J101) jumper on pin 1-2.