Descriptions of the information that appears on the screen are as follows:
Adapter Number
The active adapter or controller (1 to 8).
Number of Logical Drives
The number of defined logical drives (0 to 8).
Unattended Mode
Off - The user chooses the recovery method when there is a
ServeRAID startup error.
On - The adapter or controller chooses the recovery method when
there is a ServeRAID startup error.
Code Block Version
The current version number of the firmware loaded on the adapter or controller.
Boot Block Version
The current version number of the bootable microcode loaded on the
adapter or controller.
Concurrent Commands
The maximum number of concurrent commands supported.
Maximum Devices Supported
The maximum number of devices supported.
Flash Program Count
The current number of times the flash EEPROM has been written.
Defunct Disk Count
The current number of defunct hard disk drives.
Rebuild Rate
The current setting (Low, Medium, or High) of the rebuild rate.
Hot-Swap Rebuild
The current state (Enabled or Disabled) of the hot-swap rebuild feature.
Offline Logical Drive Count
The current number of offline logical drives.
Configuration Update Count
The number of times that the ServeRAID configuration has been updated.
NVRAM Battery Backup Device
The current state of the battery-backup cache (installed,
not installed, or defective).
Please see the LEGAL - Trademark notice.
Feel free - send a for any BUG on this page found - Thank you.