NetWare Run-Time Messages



NetWare Run-Time Messages

It is possible that an Unrecoverable, or recoverable, error might occur during normal operation of the adapter. The following table describes the run-time errors that might be displayed.

Recoverable Errors and Warnings
Error Message    FRU/Action
58: The board does not 1. If the driver is not able to recover
   respond     from any of these errors after several
   110: Unable to download the     minutes, replace the 10Base-T or 10Base2 adapter
   the firmware  
   111: Invalid Pipe Command  
   112: The board watchdog  
   failed  
   113: Adapter resetting ...  
   please wait  
   These messages indicate that  
   errors have occured during  
   the recovery process. The driver  
   will attempt to recover control  
   of the adapter at priodic intervals  
229: The adapter alert condition 1. N/A
   has been corrected  
   This message indicates the  
   successful recovery from one  
   of the above run-time error  
   conditions.  
388: Ethernet Media Port 1 Tx 1. Check cables, adapter cables or concentrator
   Carrier Sense Errors,  
   check the cable  
   389: Ethernet Media Port 2 Tx  
   Carrier Sense Errors,  
   check the cable  
   390: Ethernet Media Port 3 Tx  
   Carrier Sense Errors,  
   check the cable  
   391: Ethernet Media Port 4 Tx  
   Carrier Sense Errors,  
   check the cable  
395: Ethernet Media Port 1 Tx 1. N/A
   Carrier Sense Errors,  
   corrected  
   396: Ethernet Media Port 2 Tx  
   Carrier Sense Errors,  
   corrected  
   397: Ethernet Media Port 3 Tx  
   Carrier Sense Errors,  
   corrected  
   398: Ethernet Media Port 4 Tx  
   Carrier Sense Errors,  
   corrected  
   Problem is solved  


Unrecoverable Errors

If you receive an error that is not described in the preciding error-message lists, you might have an Unrecoverable (fatal) error. The error message indicates that the adapter has experienced an Unrecoverable run-time error.

To make the adapter functional, unload the drivers, then reload them. If unloading and reloading the drivers does not make the adapter functional, restart the computer and try again.

If the above procedures do not correct the problem, replace the 10Base-T or 10Base2 adapter.


Please see the LEGAL  -  Trademark notice.
Feel free - send a Email-NOTE  for any BUG on this page found - Thank you.