Unblocking Logical Drives
Unblocking Logical Drives: Whenever the ServeRAID controller performs a rebuild operation on an
array, the data stored in any RAID level 1 and RAID level 5 logical drives in the array is reconstructed.
However, the data stored in RAID level 0 logical drives in that array cannot be reconstructed.
The data in the RAID level 0 logical drives is blocked when the ServeRAID controller detects that the array
is valid, but the data might be damaged.
After the rebuild process completes, you can unblock the RAID level 0 logical drives, this redefines
their state as OKY and allows access to them once again. But remember, the RAID level 0 logical drive might contain
damaged data. You must re-create, install, or restore the data for the RAID level 0 logical drive from the most recent
backup disk or tape.
To unblock a blocked drive:
A screen similar to the following appears.