Turning the Power On (Netfinity EXP10 - 3520)

Turning the Power On

Use this procedure to power on the Netfinity EXP10 Storage Expansion unit.

•  Initial start-up:
  1.  Verity that all communication and power cables are plugged into the back of the Expansion Unit.
     1.  All hard disk drives are locked securely in place.
     2.  The Option ID switches on the Expansion Unit are set correctly.
     3.  The host controller and other SCSI bus devices are ready for the initial power-up.
     4.  Check the system documentation for all the hardware devices you intend to power-up  and determine the proper startup sequence.

  2.  Turn on the power to each device, based on this power-up sequence.
  3.  Turn on both power supply switches on the back of the Expansion Unit.
  4.  Only the green LEDs on the tront and back should be on. If one or more of the amber Fault  LEDs are on refer to 'Symptom-to-FRU Index'.

•  Re-starting:

   If you are re-starting after a normal shutdown, wait at least ten seconds before you attempt to turn on both    power supply switches.