BIOS Boot Block Jumper Setting (J6A1) (Netfinity 7000 - 8651)

BIOS Boot Block Jumper Setting (J6A1)

NOTE: Do not mistake this jumper block for the ones on either side.

To be able to program the boot block:

1.  Power-off the server and peripheral devices and  remove the top cover (see 'Cover (Top)').
2.  Identify the BIOS boot block jumper, J6A1.
    
   
3.  If the primary processor board blocks access to the  jumper, remove if (see 'Processor or Memory Board').
4.  Set the BIOS boot block jumper:
   1.  To remove the write-protection from the BIOS  boot block, move the jumper to pins 2 and 3.
   2.  To set the write-protection on the BIOS boot  block, move the jumper to pins 1 and 2 (factory default).

5.  If you removed the primary processor board, install it.