Hot-Swap Drive Status Indicators (Netfinity 7000

Hot-Swap Drive Status Indicators (Netfinity 7000 - 8651)

Hot-Swap Drive Status Indicators

You can use the status LEDs on the hot-swap drives to obtain status information for the drives.

Drive In-Use light (Center Green LED): The server is writing to or reading from the hard disk.
Drive Fault light (Amber LED): The SCSI drive is faulty. In a disk-array model, this amber LED blinks when the drive is part of a disk array and is being rebuilt.

The SCSI drive status condition LED indications are:

Drive In-use LED Drive Fault LED Status Off Off Hot-swap drive is present. Blinking Off Hot-swap drive is present, power to the drive is on. The drive is in use. Off On The drive has a problem, and can be replaced. Off Blinking slowly Disk-array models only: The drive should not be replaced at this time. The drive has just been replaced, and the disk array is being rebuilt. Power to the drive is on.

Drive In-use LED	Drive Fault LED	Status
Off	Off	Hot-swap drive is present.
Blinking	Off	Hot-swap drive is present, power to the drive is on. The drive is in use.
Off	On	The drive has a problem, and can be replaced.
Off	Blinking slowly	Disk-array models only: The drive should not be replaced at this time. The drive has just been replaced, and the disk array is being rebuilt. Power to the drive is on.

NOTE: If an installed drive is not recognized by the server, check the cable.

Please see the LEGAL - Trademark notice.
Feel free - send a

for any BUG on this page found - Thank you.