If a power-on password or administration password is set,
you must type the password and press Enter before POST
If an administration password is set and then forgotten, it cannot
be overridden or removed. You must replace the system board.
If a power-on password is set and forgotten, you can
regain access to the server by using either of the following
- Entering the administration password at the power-on prompt.
Start the Configuration/Setup Utility programs and change the
- Changing the position of the power-on password jumper (J27-7).
See 'Processor / System - Board'. When you restart the server, POST proceeds
without prompting for the password for this startup only. Start the
Configuration/Setup Utilities programs and set a new power-on
Leave the power-on password jumper (J27-7) in its new position,
unless you need to perform this procedure again.
Please see the LEGAL - Trademark notice.
Feel free - send a for any BUG on this page found - Thank you.