Configuring for Windows NT Server 4.0

1.  Double-click on the Network icon on the Control Panel.
2.  Click on the Adapters button, click on the Addbutton,  then click on the Have Disk button.
3.  Insert the Ethernet Configuration and Drivers diskette 1 of 2 in drive A. Then click OK
4.  When the Select OEM Optiob screen appears, highlight the IBM 100/10 PCI Ethernet Adapter. Then, click on OK

    The Ethernet Configuration and Drivers program automatically scans server resources and determines which  resources were assigned to the adapter. This may take a few seconds.

    If a message appears stating The system has not enabled busmastering on the device you are installing , the device driver  will attempt to enable mastering when it loads. Run the adapter diagnostics to see if busmastering is allowed in the slot selected.

5.  Click on Test

   NOTE:

   •  When testing a newly configured adapter, the network device driver will not be active. The diagnostic will test only  the adapter and its connection to the network.
   •  When testing a previously configured adapter, the network device driver will be active. The diagnostic will test the  adapter, its connection to the network, and the device driver. The test will also track the actual network activity of the device driver.

6.  When testing completes, click on OK to accept the configuration. Then, click on OK again.
7.  Under Network Adapter, select the IBM 100/10 PCI Ethernet Adapter. Then, click on Close

   NOTE:

    If you have other LAN protocols installed, such as TCP/IP, additional screens will appear requesting configuration information.  If this occurs, follow the instructions on the screen.

8.  Remove the Ethernet Configuration and Driver diskette from drive A.
9.  Click on Yes in the Network Settings dialog box to restart Windows NT Server Version 4.0.