Password
Password
If a power-on password or administration password is set,
you must type the password and press Enter before POST
will continue.
NOTE:
If an administration password is set and then forgotten, it cannot
be overridden or removed. You must replace the system board.
If a power-on password is set and forgotten, you can
regain access to the server by using either of the following
methods:
- Entering the administration password at the power-on prompt.
Start the Configuration/Setup Utility programs and change the
power-on password.
- Changing the position of the power-on password jumper (J12).
See 'Processor / System - Board'. When you restart the server, POST proceeds
without prompting for the password for this startup only. Start the
Configuration/Setup Utilities programs and set a new power-on
password.
Leave the power-on password jumper (J12) in its new position,
unless you need to perform this procedure again.
Please see the LEGAL - Trademark notice.
Feel free - send a 
for any BUG on this page found - Thank you.