Memory

1.  Not performing the following procedure could result in memory  errors, POST error 164, and in the operating system not  recognizing the added (or removed) memory.
2.  After you add or remove memory, you must update the  Configuration/Setup Utilities program.

1.  Power-on the server and watch the screen.
2.  When the message Press F1 to enter Configuration/Setup  appears, press F1.
3.  Select Save Settings, then exit Setup.

NOTE:

1.  The server supports 60 ns, 32 MB, 64 MB, and 128 MB,  Buffered EDO, ECC DIMMs.
2.  For signal quality, install the largest size DIMM starting from  the outside edge DIMM connector, J2. See 'Processor / System - Board'.