Numeric Error Codes and Messages

  Numeric POST Error Codes and Messages

Error Code/Message	FRU/Action in Sequence
006	1. Ensure the equipment (diskette drive, hard disk drive, keyboard,
Equipment Configuration Error	external mouse, etc.) is connected properly and is correctly set
	in the BIOS Utility.
	2. Hard disk connection board
	3. Hard disk drive
	4. Planar board
010	1. Go to 'Memory Check'.
Memory Error at	2. DIMM
MMMM:SSSS:OOOOh(R:xxxxh, W:xxxxh)	3. Planar board
040	1. Go to 'Diskette Drive Check'.
Diskette Drive Controller Error	2. Ensure the diskette drive configuration setting in BIOS Utility
	is correct.
	3. Diskette drive cable
	4. Diskette drive
	5. Planar board
047	1. Ensure the diskette drive is not set to "Disabled' in the
Diskette Drive(s) Disabled	"System Security" menu of the BIOS Utility.
	2. Diskette drive cable
	3. Diskette drive
050	1. Ensure the hard disk drive is set to "Auto' in the
IDE Drive 0 Error	"Basic System Settings" menu of the BIOS Utility.
	2. Hard disk connection board
	3. Hard disk drive
	4. Planar board
054	1. Ensure the hard disk drive is not set to "None' in the
IDE Drive(s) Disabled	"Basic System Settings" menu of the BIOS Utility.
	2. Hard disk drive cable
	3. Hard disk drive
056	1. Ensure the hard disk drive is set to "Auto' in the
IDE Drive 0 Auto	"Basic System Settings" menu of the BIOS Utility.
Detection Failed	2. Hard disk connection board
	3. Hard disk drive
	4. Planar board
070	1. Reset time in the "Basic System Settings" menu of the BIOS Utility.
Real Time Clock Error	2. Backup battery (RTC battery)
	3. Planar board
071	1. Enter BIOS Utility and execute "Load Setup Default Settings".
CMOS Battery Bad	2. Backup battery (RTC battery)
	3. Planar board
072	1. Enter BIOS Utility and execute "Load Setup Default Settings",
CMOS Checksum Error	then reboot the system.
	2. Backup battery (RTC battery)
	3. Planar board

Numeric System Operation (Runtime) Error Codes and Messages

Error Code/Message	FRU/Action in Sequence
103	1. Enter BIOS Utility and execute "Load Setup Default Settings",
Press <Esc> to turn off	then reboot the system.
NMI or other key to reboot	2. Remove the nonfactory-installed adapter card and reboot the system.