Error Log (SelectaDock II - III)



Error Log

Diagnostic errors are printed on a printer that is attached to the parallel port when the error is detected. The error is also logged in the system memory.

Use one of the following procedures to display the errors:

For SelectaDock II
  1.  End the test, if it is running.
  2.  Press Ctrl+A to select the advanced diagnostic mode.
  3.  Press Ctrl+E.
  4.  The error log appears.
  5.  To exit the screen, select the cancel icon or press Esc.


For SelectaDock III
  1.  Enter the advanced diagnostic test.
  2.  Press Ctrl+E.
  3.  The error log appears.
  4.  To exit the screen, Click on Exit or press Esc key.


The error log is not saved when the system is power is turned off.

Please see the LEGAL  -  Trademark notice.
Feel free - send a Email-NOTE  for any BUG on this page found - Thank you.