                         SEAGATE TECHNOLOGY, INC.
                              1-800-SEAGATE
                          http://www.seagate.com
                            (C)opyright 1996


ST-3271A, Filepro 270 AT (Filepro 270, CFA270A)

  ЩЭЭЭЭЭЭЭЭЭЭЭЛ
  К REAR VIEW К
  ШЭЭЭЭЭЭЭЭЭЭЭМ


                      J2  40 pin I/O Cable Connection
                      Г
           еЭЭЭЭЭЭЭЭЭ  ЭЭЭЭЭЭЭЭЭИ /ФФФФФФФФФ\    TOP (HDA)
  ЭЭЭЭЭЭЭЭЭЕ::::::::::њ::::::::1ЦЭГ 0 0 0 0 ГЭЭ
           дЭЭЭЭЭЭЭЭЭЭГЭЭЭЭЭЭЭЭЭО РФ5ФGФGФ12й    BOTTOM
                      Г
                      РФФФ pin-20 removed


     ST-3271A
  ЩЭЭЭЭЭЭЭЭЭЭЭЭЭЭЛ
  К  Front View  К              кФФФФ  Compatibility Mode
  ШЭЭЭЭЭЭЭЭЭЭЭЭЭЭМ              Г        ATA ON, ISA OFF
                                Г
                                Г кФФ  Master ON, Slave OFF (C/D)
                                Г Г
    (TOP)         o o o o o   o o o1
Option Block   ЭЭЭ  o o o o   o o o2ЭЭЭЭЭЭЭЭЭЭЭЭЭЭЭЭЭЭЭЭ
   (BOTTOM)       РФФФТФФФй   Г
                      Г       Г
          Reserved ФФФй       Г
              Reserved  ФФФФФФй


                             ST-3271A
               Filepro 270 AT (Filepro 270, CFA270A)

       FORMATTED CAPACITY _______________________265.11
       ACTUATOR TYPE ____________________________VOICE COIL
       CYLINDERS __PHYSICAL______________________2805
       HEADS ______PHYSICAL______________________2
       DISCS (3.5 in) ___________________________1
       MEDIA TYPE _______________________________THIN FILM
       HEAD TYPE ________________________________THIN FILM
       RECORDING METHOD _________________________ZBR RLL (1,7)
       INTERNAL TRANSFER RATE (Mbits/sec) _______27 to 46
       EXTERNAL TRANSFER RATE (Mbytes/sec) ______up to 11.1
       PIO MODE _________________________________2
       DMA SUPPORT ______________________________EISA Type B
       SPINDLE SPEED (RPM) ______________________4500
       AVERAGE LATENCY (mSEC) ___________________6.7
       BUFFER ___________________________________256K
        Read/Write Multiple, Read Look-Ahead,
        Multi-Segmented
       INTERFACE ________________________________ATA
       SECTORS PER DRIVE (LBA mode) _____________
       TPI (TRACKS PER INCH) ____________________3258
       BPI (KBITS PER INCH) _____________________63K
       AVERAGE ACCESS (ms) ______________________10.5
       SINGLE TRACK SEEK (ms) ___________________3
       MAX FULL SEEK (ms) _______________________26
       MTBF (power-on hours) Office _____________300,000
       SHOCK (G's):
                operating (Read/Write) __________5
                abnormal ________________________
                nonoperating ____________________75
       ACOUSTICS (bels) (typ/max) _______________43/
       POWER DISSIPATION (watts) ________________
       POWER REQUIREMENTS: +12V START-UP (amps) _1.2
       POWER MANAGEMENT (Watts):
                           ACTIVE _______________8.0
                           IDLE _________________3.9
                           STANDBY ______________1.8
       WRITE PRECOMP (cyl) ______________________N/A
       REDUCED WRITE CURRENT (cyl) ______________N/A
       LANDING ZONE (cyl) _______________________AUTO
       IBM AT DRIVE TYPE ________________________*

       Physical:
                        Height (inches/mm):  1.00/25.4
                        Width  (inches/mm):  4.00/101.6
                        Depth  (inches/mm):  5.75/146.1
                        Weight    (lbs/kg):   1.2/0.54


 * MAY REQUIRE FORMATTING AND PARTITIONING SOFTWARE.  ALSO, CHECK TO
SEE IF YOUR CMOS SETUP HAS A "CUSTOM" OR "USER DEFINABLE" DRIVE TYPE
AVAILABLE. (see below)


Possible translations: 977 cyl, 10 heads, 53 sectors = 265,118,720


Note: A "custom" or "user-definded" CMOS drivetype  may ask for a
numerical value for the Write Precompensation cylinder and for the
Landing Zone cylinder.  A basic rule-of-thumb for drive models that do
not require the old Write Precomp technique or a Landing Zone because
they are Auto-Parking is to add 1 to the cylinder value being used. As
an example: If cylinders equaled 820, then both Write Precomp and
Landing Zone would be entered as 821. Some BIOS will convert this to
65535 or -1, which are functionally equivalent to "none (not used)".

Already low-level formatted at the factory.

Since a User-definable or Custom translation geometry may be used, it
is imperative that the values be written down and kept with your
permanent records for retrieval in the event of CMOS battery failure.

Seagate reserves the right to change, without notice, product 
offerings or specifications. (02/21/96)