LAN Manager Workstation/Server

   Introduction:
   -------------
   This  document  describes  the  procedure  to   setup  LAN  Manager 2.1
   Workstation/Server driver for SURECOM EP-312 ISA PnP Ethernet Adapter.

   Location of Driver:
           (DOS) \MSLANMAN.DOS\DRIVERS\ETHERNET\EP312\PNPND.DOS
           (OS/2)\MSLANMAN.OS2\DRIVERS\ETHERNET\EP312\PNPND.OS2


   Sample Configuration Files:
   ---------------------------
      CONFIG.SYS (for DOS will contain):

         DEVICE=C:\LANMAN.DOS\DRIVERS\PROTMAN\PROTMAN.DOS /I:C:\LANMAN.DOS
         DEVICE=C:\LANMAN.DOS\DRIVERS\ETHERNET\EP312\PNPND.DOS


      CONFIG.SYS (for OS/2 will contain):

         DEVICE=C:\LANMAN.OS2\DRIVERS\PROTMAN\PROTMAN.OS2 /I:C:\LANMAN.OS2
         DEVICE=C:\LANMAN.OS2\DRIVERS\ETHERNET\EP312\PNPND.OS2


      PROTOCOL.INI (will contain):

         [RTL8019_NIF]
         ; EP312 RPOTOCOL.INI SAMPLE

           DriverName = PNPND$
           AdapterID  = @0123456789A  ;  This item is only required when
                                      ;  more than  one  EP312  adapters
                                      ;  exist on one system.

   Setup Procedures:
   -----------------
      Before you  start  with the installation process, make sure that the
      adapter  is properly  installed  and   configured.  Make  sure  your
      Microsoft LAN Manager is properly installed.

      1. Run the appropriate Microsoft Lan Manager SETUP for computer  you
         are setting up.(DOS, OS/2 or OS/2 Server). Select "Configuration"
         item ,(the SureCom driver isn't included on the Lan Manager disk)
         and insert the SureCom driver disk, select the SureCom driver and
         follow the directions.

      2. When completed, reboot your computer .


   NOTES:
   ------

      1. Parameters for the PROTOCOL.INI file:

         DRIVERNAME: This is the one required parameter.See example at top
                     of this document for syntax.

         AdapterID : This  keyword is provided by EP-312, and is  required
                     when  more  than  one  EP-312 adapters  exist  on one
                     system. You must modify the AdapterID value in  file,
                     \LANMAN\PROTOCOL.INI, by yourself.

      2. Sample PROTOCOL.INI for LAN Manager:

           [PROTMAN]
           DRIVERNAME = PROTMAN$
           DYNAMIC = YES
           PRIORITY = NETBEUI

           [NETBEUI_XIF]
           Drivername = netbeui$
           SESSIONS = 6
           NCBS = 12
           BINDINGS = "EP312_NIF"
           LANABASE = 0

           [RTL8019_NIF]
           ;
           ; EP312 PROTOCOL.INI Sample Adapter
           ;
           DriverName = PNPND$
           AdapterID  = @0123456789a