FUJITSU CORPORATION

M2488

Device Type             External Tape Drive
Interface               SCSI-2 Fast/Wide
Format                  Unidentified
Sustained Transfer Rate 20 MBPS
Size                    5.25 in. full height
View                    Top



                             DIAGNOSTIC LED(S)

   LED          Color          Status                Condition

   LED1     Unidentified         On           Prompts user to load the
                                                    cartridge.

   LED1     Unidentified        Off             Cartridge is loaded

   LED2     Unidentified         On        Drive is selected on the SCSI
                                                        bus

   LED2     Unidentified        Off         Drive is not selected on the
                                                     SCSI bus

   LED3     Unidentified         On         The drive is reading/writing
                                                  compressed data

   LED3     Unidentified        Off         The drive is reading/writing
                                                 uncompressed data

  Note: LED’s 4 through 10 each represent the different tape positions
  between BOT and EOT. When the tape is moving in the forward position,
  the LED’s light up sequentially starting from the BOT position. When
  the tape is moving in reverse, the LED’s light up sequentially in the
  reverse order.

                       MISCELLANEOUS TECHNICAL NOTES

  The IPM is an adapter card that is available in four different
  configurations: 50-pin SCSI connector (2x), 68-pin SCSI connector (2x),
  50-pin SCSI connector & Terminating Resistor, 68-pin SCSI connector &
  Terminating Resistor. The Termination Power is supplied by the SCSI
  interface through pin 36. This setting is only valid with this specific
  IPM installed.