ACEEX CORPORATION DM-56V14H (EXTERNAL - ALUMINUM CASE) Card Type Modem Chip Set Unidentified I/O Options Line out, line in, 25-pin DTE port, power Maximum Modem Rate 56Kbps Maximum Fax Rate 14.4Kbps Data Modulation Protocol Bell 103/212A ITU-T V.21, V.22, V.22bis, V.23, V.32, V.32bis, V.34, V.34+, K56flex Fax Modulation Protocol ITU-T V.17, V.21 CH2, V.27ter, V.29 Error Correction/Compression MNP5, V.42, V.42bis Fax Class Unidentified Data Bus External [Image] CONNECTIONS Function Label Function Label Power CN1 Line out (RJ-11) CN4 25-pin DTE port CN2 Power switch SW1 Line in (RJ-11) CN3 DIAGNOSTIC LEDS LED Color Status Condition CTS Unidentified On CTS signal is high. Device is ready to send data CTS Unidentified Off CTS signal is low AA Unidentified On Auto-answer enabled AA Unidentified Off Auto-answer disabled CD Unidentified On Carrier signal detected or error correction negotiation completed CD Unidentified Off Carrier signal not detected OH Unidentified On Modem is off hook OH Unidentified Off Modem is on hook RD Unidentified On Modem is receiving data RD Unidentified Off Modem is not receiving data SD Unidentified On Modem is transmitting data SD Unidentified Off Modem is not transmitting data TR Unidentified On DTR signal is high TR Unidentified Off DTR signal is low MR Unidentified On Power is on MR Unidentified Off Power is off SUPPORTED COMMAND SET Basic AT Commands AT, ‘+++’, A/ A, B, C, E, H, M, O, P, Q, T, V, W, X, Y, Z &C, &P, &Q, &R, &T, &V, &W, &Y, &Z Extended AT Commands %C, %E, %L, %Q \A, \B, \K, \N, \V Special Commands -K S Registers S0, S1, S2, S3, S4, S5, S6, S7, S8, S9,S10, S11, S12, S14, S16, S18, S21, S22, S23, S24, S25 S26, S27, S28, S29, S30, S31, S32, S33, S37, S39, S41, S91, S92 Note: See MHI Help File for full command documentation. PROPRIETARY AT COMMAND SET For a full command summary, see ACEEX CORPORATION DM-56V14H (INTERNAL)