PATTON ELECTRONICS COMPANY

2089

Card Type                 Interface Converter
Chip Set                  Unidentified
I/O Options               9-pin serial port, network interface via RJ-45,
                          RJ-11 or terminal block
Wiring Type               Unshielded twisted pair
Maximum Data Rate         115.2Kbps
Data Bus                  External

[Image]

                                CONNECTIONS

         Function             Label            Function             Label

  DTE/DCE serial port          CN1     UTP interface (RJ-45,        CN2
  (9-pin connector)                    RJ-11 or terminal block)

                        USER CONFIGURABLE SETTINGS

                  Setting                       Label         Position

  »   Receive impedance set low (120Ohms)        S1/1            On

      Receive impedance set high (16kOhms)       S1/1           Off

  »   Echo mode disabled                         S1/4           Off

      Echo mode enabled                          S1/4            On

  »   Carrier controlled by RTS                  S2/1            On

      Carrier forced high                        S2/1           Off

  »   8ms RTS/CTS delay enabled                  S2/2            On

      RTS/CTS delay disabled                     S2/2           Off

                          TRANSMIT LINE IMPEDENCE

                    Setting                         S2/3          S2/4

  »            High impedence enabled                Off          Off

           Intermediate impedence enabled            On            On

                       2-WIRE/4-WIRE MODE SELECTION

                   Setting                         S1/2          S1/3

  »             2-wire mode enabled                 On            On

            4-wire mode enabled enabled             Off           Off