DIGICOM SPA DONATELLO (INTERNAL), DONATELLO MAC (INTERNAL) Card Type ISDN, Modem Chip Set Unidentified I/O Options ISDN interface via RJ-45 connector, headphone, microphone, speaker, 25-pin serial port, power ISDN Rate 64Kbps x 2 Maximum Modem Rate 33.6Kbps Maximum Fax Rate 14.4Kbps ISDN Modulation Protocol V.110, V.120 Data Modulation Protocol Bell 103J/212A, ITU-T V.21, V.22, V.22bis,V.23, V.32, V.32bis, V.34, K56flex Fax Modulation Protocol V.17, V.29, V.27 Error Correction/Compression MNP5, V.42, V.42bis Fax Class Class I Data Bus 16-bit ISA [Image] CONNECTIONS Function Label Function Label ISDN interface (RJ-45 CN1 Reset P1 connector) USER CONFIGURABLE SETTINGS Setting Label Position Transmission channel in high impedence U4 Pins 2 & 3 closed mode Transmit termination set to 100Ohm U4 Pins 1 & 2 closed Receive channel in high impedence mode U5 Pins 2 & 3 closed Receive termination set to 100Ohm U5 Pins 1 & 2 closed Interrupt 14 enabled U8 Pins 2 & 3 closed Interrupt 14 disabled U8 Pins 1 & 2 closed ADDRESS SELECTION Setting DS1/1 DS1/2 COM1 (3F8h) Off Off COM2 (2F8h) Off On COM3 (3E8h) On Off COM4 (2E8h) On On INTERRUPT SELECTION IRQ DS1/3 DS1/4 DS1/5 DS1/6 DS1/7 DS1/8 IRQ3 On Off Off Off Off Off IRQ4 Off On Off Off Off Off IRQ5 Off Off On Off Off Off IRQ10 Off Off Off Off On Off IRQ11 Off Off Off Off Off On SUPPORTED COMMAND SET (DIGITAL) Basic AT Commands AT, A/ A, E, Q, V, W &C, &Z S Registers S2, S3, S4, S12, S25, S26 Note: See MHI Help File for full command documentation. SUPPORTED COMMAND SET (ANALOG) Basic AT Commands AT, A/ A, B, E, H, L, M, O, Q, V, W, X, Y, Z &C, &G, &T, &V, &W, &Y, &Z Extended AT commands \A, \B, \K, \N %C, %E, %L, %Q #CID S Registers S0, S1, S2, S3, S4, S5, S6 ,S7, S8, S9, S10, S11, S12, S18, S29, S30, S32, S33 Special commands +MS, -K, )M Voice AT commands #VBT, #VRX, #VSP, #VSR, #VSS, #VTS, #VTX Note: See MHI Help File for full command documentation. For a full command summary, see DIGICOM SPA DONATELLO (EXTERNAL), DONATELLO MAC (EXTERNAL)