PARADYNE CORPORATION ACCULINK 3164 DSU/CSU Card Type DSU/CSU NIC Type T1 Chip Set Unidentified I/O Options DTE ports (5), network interface via RJ-45, modem port test jacks (6), power jack, auxiliary port, communications port Maximum Modem Rate 2400bps Data Modulation Protocol V.22 Wiring Type RJ-48 120ohm shielded twisted pair Maximum Data Rate 56Kbps (64Kbps full duplex) Data Bus External [Image] CONNECTIONS Function Label Function Label Test jack - line in CN1 Modem port via RJ-11 CN10 Test jack - line in CN2 DTE port (15-pin CN11 connector) Test jack - line in CN3 Network interface via CN12 RJ-45 connector Test jack - line out CN4 15-pin clock port CN13 Test jack - line out CN5 DTE port 1 (25-pin CN14 serial connector) Test jack - line out CN6 DTE port 2 (25-pin CN15 serial connector) Power Jack CN7 DTE port 3 (25-pin CN16 serial connector) Auxiliary port CN8 DTE port 4 (25-pin CN17 serial connector) Communications port CN9 DIAGNOSTIC LED(S) LED Color Status Condition OK Green On DSU/CSU power is on OK Green Blinking DSU/CSU is downloading software OK Green Off DSU/CSU power is off or detecting a system failure FAIL Yellow On Error has been detected on network FAIL Yellow Off Error has not been detected on network FAIL Yellow Blinking DSU/CSU is conducting a self test TST Yellow On DSU/CSU is executing a test TST Yellow Off DSU/CSU is not executing a test SIG Green On DSU/CSU is receiving a recoverable signal from network SIG Green Off DSU/CSU cannot recover the signal from network OOF Yellow On Out of frame condition detected on network OOF Yellow Off Out of frame condition not detected on network ALM Yellow On Alarm condition detected on network ALM Yellow Off Alarm condition not detected on network EER Yellow On Excessive error rate exceeded on network EER Yellow Off Excessive error rate not exceeded on network DTE DROP/INSERT AND DATA PORT LED(S) LED Color Status DTE drop/insert Data port port LED1 Green On A recoverable DTR signal is high signal is being received from network LED1 Green Off DSU/CSU cannot DTR signal is low recover the signal from network LED2 Yellow On Out of frame Receiving all zeros condition detected from the DTE on network LED2 Yellow Off Out of frame Receiving all ones condition not from the DTE detected on network LED2 Yellow Blinking N/A Data is being transferred LED3 Yellow On Alarm condition Transmitting all detected on zeros from the DTE network LED3 Yellow Off Alarm condition Transmitting all not detected on ones from the DTE network LED3 Yellow Blinking N/A Data is being transferred LED4 Yellow On A pulse density CTS signal is high violation was detected (and corrected) on network LED4 Yellow Off A pulse density CTS signal is low violation was not detected on network LED5 Yellow On A bipolar RTS signal is high violation was detected (and corrected) on network LED5 Yellow Off A bipolar RTS signal is low violation was not detected on network