PARADYNE CORPORATION 7610 SNMP DSU Card Type DSU Chip Set Unidentified I/O Options DTE/DCE ports (2), network interface via RJ-48, power jack, DTE port Wiring Type RJ-45 Unshielded twisted pair RJ-48 T1 Maximum Data Rate 56Kbps (64Kbps full duplex or clear channel) Data Modulation Protocol DDS, LADS Data Bus External [Image] CONNECTIONS Function Label Function Label Power Jack CN1 DTE port (V.35 CN4 connector) DTE/DCE port (25-pin CN2 Network interface via CN5 serial connector) RJ-48 connector DTE/DCE port (25-pin CN3 serial connector) DIAGNOSTIC LED(S) LED Color Status Condition OK Green On DSU power is on OK Green Off DSU power is off, performing a self test, or detecting a system failure ALM Red On DSU has detected an alarm condition ALM Red Off DSU has not detected an alarm condition TST Yellow On DSU is executing a test TST Yellow Off DSU is not executing a test DM Green On Data is being transmitted/received DM Green Off CMI codes are being received OOS Red On DSU is receiving an out of service code from remote unit OOS Red Off DSU is not receiving an out of service code from remote unit OOF Red On DSU is detecting an out of frame condition OOF Red Off DSU is not detecting an out of frame condition NS Red On Carrier signal not detected NS Red Off Carrier signal detected TXD Green On Receiving all zeros from the DTE TXD Green Off Receiving all ones from the DTE TXD Green Blinking Data is being transferred RXD Green On Transmitting all zeros from the DTE RXD Green Off Transmitting all ones from the DTE RXD Green Blinking Data is being transferred RTS Green On RTS signal is high RTS Green Off RTS signal is low CTS Green On CTS signal is high CTS Green Off CTS signal is low DTR Green On DTR signal is high DTR Green Off DTR signal is low