IQ SYSTEMS, INC.

IQS80X

Card Type                 Speech messaging card
Chip Set                  Unidentified
Maximum Onboard Memory    4MB EPROM or EEPROM/FLASH
I/O Options               Power jack, speaker jack, RJ-11 host system
                          connector
Hard Drives supported     None
Floppy drives supported   None
Data Bus                  External

[Image]

                                CONNECTIONS

          Function            Label            Function            Label

  10-pin host system            H1     RJ-11 host system             J3
  connector                            connector

  Power jack                    J1     Reset button                  S1

  Speaker jack                  J2

                        USER CONFIGURABLE SETTINGS

                    Function                      Label      Position

  Reset signal through J3 enabled                 JP11        Closed

  Reset signal through J3 disabled                JP11         Open

                        MEMORY JUMPER CONFIGURATION

       MEM-A               MEM-B         JP1    JP2    JP5    JP6    JP7

  512KB x 8 EPROM     512KB x 8 EPROM     1 &   1 &    1 &    1 &    1 &
                                          2      2      2      2      2

      512KB x 8          512KB x 8        2 &   2 &    1 &    1 &    1 &
    EEPROM/FLASH       EEPROM/FLASH       3      3      2      2      2

  512KB x 8 EPROM         32KB x 8        1 &   1 &    2 &    2 &    2 &
                        SRAM/EEPROM       2      2      3      3      3

      512KB x 8           32KB x 8        2 &   2 &    2 &    2 &    2 &
    EEPROM/FLASH        SRAM/EEPROM       3      3      3      3      3

  Note: Pins designated are in the closed position. Supports two
  4MB(512KB x 8)EPROM or EEPROM flash memories or one 4MB ROM and one
  256KB(32KB x 8)SRAM or EEPROM.

                      SERIAL COMMUNICATIONS SELECTION

    Communications       Connector      JP3      JP8     JP9       JP10

        UART -            J3 or H1      Pins     Pins    Pins      Open
    TTL/ObjectLink                     1 & 2    1 & 2    1 & 2

    UART - RS-232            J3         Pins     Pins    Pins     Closed
                                       1 & 2    2 & 3    2 & 3

     RS-485 - TTL            H1         Pins     Pins    Pins      Open
                                       2 & 3    1 & 2    1 & 2

  Note: Pins designated are in the closed position.