AMERICAN DATA AQUISITION CORPORATION 5508LF REV. 1-USI=2 Card Type Data Aquisition Chip Set Unidentified Maximum Onboard Memory Unidentified I/O Options Analog input, digital input Hard Drives supported None Floppy drives supported None Data Bus 8-bit ISA Card Size Half length [Image] CONNECTIONS Function Label Function Label Header connector to J1 A/D converter range P2 expansion board selector 37-pin analog/digital J3 Unipolar offset P3 signals connector selector Bipolar offset selector P1 USER CONFIGURABLE SETTINGS Function Label Position » 8 channel mode Z10/7 Off 16 channel mode Z10/7 On GAIN SELECTION Function W1 W2 » Programmable gain options: x1, Open Open x2, x5, x10 Programmable gain options: x1, Closed Closed x2, x4, x8 DMA CHANNEL SELECTION Channel JP6/A JP6/B JP6/C JP7/A JP7/B JP7/C » Disabled Open Open Open Open Open Open 1 Closed Open Open Closed Open Open 2 Open Closed Open Open Closed Open 3 Open Open Closed Open Open Closed A/D RANGE SELECTION Polarity Voltage JP1 JP2 Z10/8 » Bipolar + 10V Pins 2 & 3 Pins 2 & 3 On closed closed Bipolar + 5V Pins 2 & 3 Pins 1 & 2 On closed closed Unipolar +0-10V Pins 1 & 2 Pins 1 & 2 Off closed closed BASE I/O ADDRESS SELECTION Setting Z10/1 Z10/2 Z10/3 Z10/4 Z10/5 Z10/6 000h Off Off Off Off Off Off 010h Off Off Off Off Off On 020h Off Off Off Off On Off 030h Off Off Off Off On On 040h Off Off Off On Off Off » 120h Off On Off Off On Off 3B0h On On On Off On On 3C0h On On On On Off Off 3D0h On On On On Off On 3E0h On On On On On Off 3F0h On On On On On On Note: A total of 64 base address settings are available. The switches are a binary representation of the decimal memory addresses. Z10/1 is the Most Significant Bit and switch Z10/6 is the Least Significant Bit. The switches have the following decimal values: Z10/1=512, Z10/2=256, Z10/3=128, Z10/4=64, Z10/5=32, Z10/6=16. Turn off the switches and add the values of the switches to obtain the correct memory address. (On=1, Off=0)