AMERICAN DATA AQUISITION CORPORATION 5803HR, 5804HR Card Type Data Aquisition Chip Set Unidentified Maximum Onboard Memory Unidentified I/O Options Analog input, digital input Hard Drives supported None Floppy drives supported None Data Bus 16-bit ISA Card Size Full-length [Image] CONNECTIONS Function Label Function Label 40-pin header to 37-pin J1 DAC1 range selector P6 analog/digital signals connector via cable 40-pin header to 37-pin J2 A/D converter offset P11 analog/digital signals selector connector via cable 50-pin analog/digital J8 A/D converter range P12 signals connector selector DAC0 unipolar offset P1 A/D converter x10 P13 selector gain selector DAC0 bipolar offset P2 A/D converter x100 P14 selector gain selector DACO range selector P3 A/D converter x500 P15 gain selector DAC1 unipolar offset P4 A/D converter common P16 selector mode selector DAC1 bipolar offset P5 selector BASE I/O ADDRESS SELECTION Setting SW1/1 SW1/2 SW1/3 SW1/4 SW1/5 000h Off Off Off Off Off 020h Off Off Off Off On 040h Off Off Off On Off 060h Off Off Off On On 080h Off Off On Off Off » 120h Off On Off Off On 360h On On Off On On 380h On On On Off Off 3A0h On On On Off On 3C0h On On On On Off 3E0h On On On On On Note: A total of 32 base address settings are available. The switches are a binary representation of the decimal memory addresses. SW1/1 is the Most Significant Bit and jumper SW1/5 is the Least Significant Bit. The jumpers have the following decimal values: SW1/1=512, SW1/2=256, SW1/3=128, SW1/4=64, SW1/5=32. Turn off the switches and add the values of the switches to obtain the correct memory address. (On=1, 0ff=0)