ASTROCOM CORPORATION NX1 Card Type T1 CSU/DSU Chipset Unidentified T1 Transfer Rate 56Kbps x 24/64Kbps x 24 T1 Protocol AMI, B8ZS Frame Type D4, SF, ESF Data Bus Serial [Image] CONNECTIONS Function Label Function Label LEFT button BT1 T1 line out (Network CN3 Interface) ENTER button BT2 T1 line in (Terminal CN4 Interface) RIGHT button BT3 Serial control port CN5 AC power in CN1 LCD display LCD V.35, RS-422, or CN2 Power switch SW1 RS-449 serial data port Note:The type of serial port CN2 is determined by which daughtercard is installed in the unit. No further information about the daughtercard is available. DIAGNOSTIC LED(S) LED Color Status Condition RED Unidentified On T1 signal has been out of frame for more than 2.5 seconds RED Unidentified Off T1 signal has not been out of frame for more than 2.5 seconds YEL Unidentified On Yellow alarm signal detected YEL Unidentified Off Yellow alarm signal not detected AIS Unidentified On All Ones Signal detected AIS Unidentified Off All Ones Signal not detected LOS Unidentified On Loss of Signal condition detected for more than 150ms LOS Unidentified Off Loss of Signal condition not detected for more than 150ms SES Unidentified On Large quantity of errors detected in the last second SES Unidentified Off Small quantity of errors detected in the last second DIAGNOSTIC LED(S) (CON'T) LED Color Status Condition T1A Unidentified On Valid signal detected on T1 network interface T1A Unidentified Off Valid signal not detected on T1 network interface DTEA Unidentified On Valid signal detected at DTE DTEA Unidentified Off Valid signal not detected at DTE DS1A Unidentified On Valid signal detected on T1 terminal interface DS1A Unidentified Off Valid signal not detected on T1 terminal interface T1B Unidentified On T1 network interface in test mode T1B Unidentified Off T1 network interface not in test mode DTEB Unidentified On DTE in test mode DTEB Unidentified Off DTE not in test mode DS1B Unidentified On T1 terminal interface in test mode DS1B Unidentified Off T1 terminal interface not in test mode