3COM CORPORATION IMPACT (3C870, 3C875) Card Type ISDN TA Chipset Unidentified Error Correction/Compression STAC ISDN Transfer Rate 56Kbps x 2/64Kbps x 2 ISDN Protocol V.120, PPP Switch Type 5ESS, DMS100, EWSD, NI-1 Data Bus Serial [Image] CONNECTIONS Function Label Function Label ISDN interface CN1 DC power in CN4 Serial port CN2 Power switch SW1 Analog adapter CN3 DIAGNOSTIC LED(S) LED Color Status Condition B2 Green On Data call connected on B2 channel B2 Yellow On Voice call connected on B2 channel B2 Green Blinking TA is dialing data call on B2 channel B2 Yellow Blinking TA is dialing voice call on B2 channel B2 N/A Off B2 channel is not connected B1 Green On Data call connected on B1 channel B1 Yellow On Voice call connected on B1 channel B1 Green Blinking TA is dialing data call on B1 channel B1 Yellow Blinking TA is dialing voice call on B1 channel B1 N/A Off B1 channel is not connected DIAGNOSTIC LED(S) (CON'T) LED Color Status Condition D Yellow On Signal is not synchronized or ISDN line is not connected D Yellow Blinking Signal is synchronized but D-channel protocols not established D Yellow Off Signal is synchronized TEST Yellow On TA failed last test TEST Yellow Blinking TA is executing test TEST Yellow Off TA is not executing test POWER Yellow On Power is on POWER Yellow Off Power is off SUPPORTED STANDARD COMMANDS Basic AT Commands +++, A/ A, D, E, H, O, V, Z &D, &F, &W Extended AT Commands \Q, \T S-Registers S0 Note: See MHI help file for complete information. UNIDENTIFIED COMMANDS Command Default S63 Unidentified S64 Unidentified Proprietary AT Command Set CALL TYPE Type: Register Format: AT [cmds] S61=n [cmds] Description: Selects the type of call the TA will make. Command Function S61=0 TA will dial according to dial modifiers. S61=1 TA will place Switched 56 call. S61=2 TA will place ISDN call. S61=3 TA will place modem call. S61=4 TA will place voice call. S61=5 TA will use third-party call control. See 3COM CORPORATION IMPACT (3C871) for a full command summary.