RAD DATA COMMUNICATIONS CMN-CF6A (SMA) Card Type Modem (asynchronous) Chipset Unidentified Wire Type Fiber optic cable Maximum Data Rate 19.2Kbps x 2 Data Modulation Unidentified Data Bus Proprietary [Image] CONNECTIONS Function Label Function Label Serial data port 1 CN1 Serial data port 2 CN3 Fiber optic SMA cable 1 CN2 Fiber optic SMA cable 2 CN4 USER CONFIGURABLE SETTINGS Setting Label Position Factory configured - do not alter JP1 Unidentified Factory configured - do not alter JP2 Unidentified RTS to CTS delay set to 2mS on modem 1 SW1/1 Off RTS to CTS delay set to 15mS on modem 1 SW1/1 On DCD forced high on modem 1 SW1/2 On DCD follows DTR on modem 1 SW1/2 Off RTS to CTS delay set to 2mS on modem 2 SW2/1 Off RTS to CTS delay set to 15mS on modem 2 SW2/1 On DCD forced high on modem 2 SW2/2 On DCD follows DTR on modem 2 SW2/2 Off Cable shield 1 connected to signal ground SW3/1 On Cable shield 1 not connected to signal ground SW3/1 Off Signal ground 1 not connected to chassis ground SW3/2 Off Signal ground 1 connected to chassis ground SW3/2 On Cable shield 2 connected to signal ground SW4/1 On Cable shield 2 not connected to signal ground SW4/1 Off Signal ground 2 not connected to chassis ground SW4/2 Off Signal ground 2 connected to chassis ground SW4/2 On CN1 is DCE SW5 On CN1 is DTE SW5 Off CN3 is DCE SW6 On CN3 is DTE SW6 Off DIAGNOSTIC LED(S) LED Color Status Condition PWR Green On Power is on PWR Green Off Power is off XMT1 Yellow On Modem 1 is transmitting data XMT1 Yellow Off Modem is 1 not transmitting data RCV1 Yellow On Modem 1 is receiving data RCV1 Yellow Off Modem 1 is not receiving data DCD1 Yellow On Carrier signal detected on line 1 DCD1 Yellow Off Carrier signal not detected on line 1 XMT2 Yellow On Modem 2 is transmitting data XMT2 Yellow Off Modem is 2 not transmitting data RCV2 Yellow On Modem 2 is receiving data RCV2 Yellow Off Modem 2 is not receiving data DCD1 Yellow On Carrier signal detected on line 1 DCD1 Yellow Off Carrier signal not detected on line 1 MISCELLANEOUS TECHNICAL NOTE This card is intended for use in the CMN-16 rack-mount system. The bus is used only for supplying power for the card. All other card functions are accessed through the serial ports.