COMTROL CORPORATION HOSTESS 4/8, HOSTESS 550 4/8 Card Type Serial Chipset 16450 (Hostess 4/8) or 16550 (Hostess 550 4/8) I/O Options Serial ports (8) Data Bus 16-bit ISA Card Size Full height, half length [Image] CONNECTIONS Function Label Function Label Serial ports via 100-pin J1 Header for 4-port J3 connector daughterboard Header for 4-port J2 daughterboard USER CONFIGURABLE SETTINGS Setting Label Position » Card does not have 4-port JP1 Pins 2 & 3 closed daughterboard installed Card has 4-port daughterboard JP1 Pins 1 & 2 closed installed Interrupt mask enabled SW2/1 On Interrupt mask disabled SW2/1 Off » Factory configured - do not alter SW2/8 Unidentified Note:SW2/8 must be off if the daughterboard is installed. COMTROL MODE ADDRESS SELECTION Setting SW1/1 SW1/2 SW1/3 SW1/4 SW1/5 SW1/6 SW1/7 SW1/8 0000h On On On On On On On On 0020h Off On On On On On On On 0040h On Off On On On On On On 0060h Off Off On On On On On On 0080h On On Off On On On On On » 0280h On On Off On Off On On On 1F60h Off Off On Off Off Off Off Off 1F80h On On Off Off Off Off Off Off 1FA0h Off On Off Off Off Off Off Off 1FC0h On Off Off Off Off Off Off Off 1FE0h Off Off Off Off Off Off Off Off Note: A total of 512 base address settings are available. The switches are a binary representation of the decimal memory addresses. SW1/8 is the Most Significant Bit and switch SW1/1 is the Least Significant Bit. The switches have the following decimal values: SW1/8=4096, SW1/7=2048, SW1/6=1024, SW1/5=512, SW1/4=256, SW1/3=128, SW1/2=64, SW1/1=32. Turn off the switches and add the values of the switches that are off to obtain the correct memory address. (Off=1, On=0) SW1/1 must be off if the daughterboard is installed. INTERRUPT SELECTION Setting JP2 SW2/2 SW2/3 SW2/4 SW2/5 SW2/6 SW2/7 2 Pins On Off Off Off Off Off 1 & 2 3 Pins Off On Off Off Off Off 1 & 2 4 Pins Off Off On Off Off Off 1 & 2 5 Pins Off Off Off On Off Off 1 & 2 7 Pins Off Off Off Off Off Off 2 & 3 10 Pins Off Off Off Off On Off 1 & 2 11 Pins Off Off Off Off Off On 1 & 2 Note:Pins designated are in the closed position. IRQ7 is only available on boards that have SW2 marked with INTERRUPT.