APACHE MICRO PERIPHERALS, INC. APACHE V34-M Card Type Modem (asynchronous) Chip Set Rockwell ACi I/O Options None Maximum Data Rate 28.8Kbps Maximum Fax Rate 14.4Kbps Data Bus Serial Fax Class Unidentified Data Modulation Protocol Bell 103A/212A ITU-T V.21, V.22, V.22bis, V.32, V.32bis, V.34 Rockwell V.FC Fax Modulation Protocol Unidentified Error Correction/Compression MNP5, V.42, V.42bis [Image] CONNECTIONS Function Label Function Label Line in CN1 DC power CN4 Line out CN2 Power switch SW1 RS-232/422 CN3 DIAGNOSTIC LED(S) LED Color Status Condition PWR Unidentified On Power is on PWR Unidentified Off Power is off DR Unidentified On DTR signal is high DR Unidentified Off DTR signal is low RLSD Unidentified On Carrier signal detected RLSD Unidentified Off Carrier signal not detected TD Unidentified On Modem is transmitting data TD Unidentified Off Modem is not transmitting data RD Unidentified On Modem is receiving data RD Unidentified Off Modem is not receiving data OH Unidentified On Modem is off-hook OH Unidentified Off Modem is on-hook MR Unidentified On Modem is ready MR Unidentified Off Modem is not ready HS Unidentified On Modem is operating at 4800bps or faster HS Unidentified Off Modem is operating at slower than 4800bps AA Unidentified On Auto-answer enabled AA Unidentified Off Auto-answer disabled SUPPORTED STANDARD COMMANDS Basic AT Commands +++, ‘comma’, A/ A, B, E, H, L, M, N, O, P, Q, T, V, W, X, Y, Z &C, &D, &F, &G, &K, &P, &Q, &R, &S, &T, &V, &W, &Y, &Z Extended AT Commands \A, \B, \K, \N %C, %E, %L, %Q Special AT Commands #CID, +MS S-Registers S0, S1, S2, S3, S4, S5, S6, S7, S8, S9, S10, S11, S12, S14, S16, S18, S21, S22, S23, S25, S26 S27, S29, S30, S31, S32, S33, S36, S38, S46, S48, S82, S86, S95 Note: See MHI documentation for complete information. Registers S39, S40, and S41 are unidentified bit-mapped registers. Proprietary AT Command Set See APACHE MICRO PERIPHERALS, INC. APACHE V34I-M for a full command summary.