ACQUTEK CORPORATION

PM-9008

Card Type              Solid-state disk
Chipset                Unidentified
Maximum Onboard Memory 2MB SRAM/8MB Flash ROM or EPROM
Data Bus               8-bit ISA

[Image]

                                CONNECTIONS

               Function                               Label

  External battery connector (see                      JP1
  pinout below)

                                JP1 PINOUT

          Function             Pin             Function              Pin

  Battery positive in           1      Battery negative to            3
                                       ground

  Battery positive in           2      Battery negative to            4
                                       ground

                        USER CONFIGURABLE SETTINGS

                  Setting                       Label        Position

  »   On-board battery enabled                   JP2          Closed

      On-board battery disabled                  JP2           Open

  »   Shared memory address set to D0000h        JP3          Closed

      Shared memory address set to DC000h        JP3           Open

  »   Base I/O address set to 200h               JP4          Closed

      Base I/O address set to 380h               JP4           Open

  »   SRAM is not write protected                JP5           Open

      SRAM is write protected                    JP5          Closed

      Chip M1 contains SRAM                     SW1/1           On

      Chip M1 contains EPROM or Flash ROM       SW1/1           Off

      Chip M2 contains SRAM                     SW1/2           On

      Chip M2 contains EPROM or Flash ROM       SW1/2           Off

      Chip M3 contains SRAM                     SW1/3           On

      Chip M3 contains EPROM or Flash ROM       SW1/3           Off

      Chip M4 contains SRAM                     SW1/4           On

      Chip M4 contains EPROM or Flash ROM       SW1/4           Off

                    USER CONFIGURABLE SETTINGS (CON’T)

                      Setting                        Label     Position

  Chip M5 contains SRAM                              SW1/5        On

  Chip M5 contains EPROM or Flash ROM                SW1/5       Off

  Chip M6 contains SRAM                              SW1/6        On

  Chip M6 contains EPROM or Flash ROM                SW1/6       Off

  Chip M7 contains SRAM                              SW1/7        On

  Chip M7 contains EPROM or Flash ROM                SW1/7       Off

  Chip M8 contains SRAM                              SW1/8        On

  Chip M8 contains EPROM or Flash ROM                SW1/8       Off

  Chip M9 contains SRAM                              SW3/1        On

  Chip M9 contains EPROM or Flash ROM                SW3/1       Off

  Chip M10 contains SRAM                             SW3/2        On

  Chip M10 contains EPROM or Flash ROM               SW3/2       Off

  Chip M11 contains SRAM                             SW3/3        On

  Chip M11 contains EPROM or Flash ROM               SW3/3       Off

  Chip M12 contains SRAM                             SW3/4        On

  Chip M12 contains EPROM or Flash ROM               SW3/4       Off

  Chip M13 contains SRAM                             SW3/5        On

  Chip M13 contains EPROM or Flash ROM               SW3/5       Off

  Chip M14 contains SRAM                             SW3/6        On

  Chip M14 contains EPROM or Flash ROM               SW3/6       Off

  Chip M15 contains SRAM                             SW3/7        On

  Chip M15 contains EPROM or Flash ROM               SW3/7       Off

  Chip M16 contains SRAM                             SW3/8        On

  Chip M16 contains EPROM or Flash ROM               SW3/8       Off

                              DRIVE SELECTION

       Setting           SW2/1        SW2/2        SW2/3         SW2/4

            A:            On           Off          Off           Off

  »         B:            Off           On          Off           Off

            C:            Off          Off           On           Off

            D:            Off          Off          Off           On

         Disabled         Off          Off          Off           Off

                           MEMORY CONFIGURATION

            The memory sockets (M1 - M16) on the PM-9008 accept SRAM
            chips (62010), EPROM chips (27010, 27020, or 27040), and
            Flash EPROM chips (28F010, 28F020, or 28F040). The Sockets
            can be filled in any order and SRAM chips can be mixed with
            either EPROMs or Flash EPROMs, however all EPROM or Flash
            EPROM must be the same size (i.e. all 27010 chips or all
            28F040 chips).