MITSUMI ELECTRONICS CORPORATION EXTERNAL CD-ROM INTERFACE CARD (VER. 1) Card Type CD-ROM interface card Chip Set Unidentified Maximum Onboard Memory None I/O Options None Data Bus 8-bit ISA Floppy drives supported None [Image] CONNECTIONS Function Label CD-ROM interface connector CN1 USER CONFIGURABLE SETTINGS Function Label Position » Factory configured - do not alter SW2/1 On » Factory configured - do not alter SW2/2 On » Factory configured - do not alter SW2/3 On » Factory configured - do not alter SW2/4 Off » Factory configured - do not alter SW2/5 Off » Factory configured - do not alter SW2/6 Off » Factory configured - do not alter SW2/7 Off » Factory configured - do not alter SW2/8 Off DMA CHANNEL SELECTION Channel JP2/A JP2/B JP2/C JP2/D 1 Closed Closed Open Open » 3 Open Open Closed Closed BASE I/O ADDRESS SELECTION Setting SW1/1 SW1/2 SW1/3 SW1/4 SW1/5 SW1/6 SW1/7 SW1/8 0h On On On On On On On On 4h Off On On On On On On On 8h On Off On On On On On On Ch Off Off On On On On On On 10h On On Off On On On On On » 300h On On On On On On Off Off 3ECh Off Off On Off Off Off Off Off 3F0h On On Off Off Off Off Off Off 3F4h Off On Off Off Off Off Off Off 3F8h On Off Off Off Off Off Off Off 3FCh Off Off Off Off Off Off Off Off Note:A total of 256 base address settings are available. The switches are a binary representation of the decimal memory addresses. SW1/8 is the Most Significant Bit and switch SW1/1 is the Least Significant Bit. The switches have the following decimal values: SW1/8=512, SW1/7=256, SW1/6=128, SW1/5=64, SW1/4=32, SW1/3=16, SW1/2=8, SW1/1=4. Turn off the switches and add the values of the switches to obtain the correct memory address. (Off=1, On=0) INTERRUPT SELECTION IRQ JP1/A JP1/B JP1/C IRQ2 Closed Open Open » IRQ3 Open Closed Open IRQ5 Open Open Closed