DIGICOM SYSTEMS, INC. CONNECTION 96+ Card Type Fax, Modem (asynchronous) Chip Set Unidentified Maximum Data Rate 14.4Kbps Maximum Fax Rate 14.4Kbps Data Bus 8-bit ISA Fax Class Class I Data Modulation Protocol Bell 103/212A ITU-T V.21, V.22, V.22bis, V.23, V.32, V.32bis Fax Modulation Protocol ITU-T V.17, V.21CH2, V.27ter, V.29 Error Correction/Compression MNP5, V.42, V.42bis [Image] CONNECTIONS Function Label Function Label Line in CN1 Line out CN2 SERIAL PORT ADDRESS Setting SW1/1 SW1/2 SW1/3 SW1/4 COM1 (3F8h) Off Off Off On COM2 (2F8h) On Off Off On COM3 (3E8h) Off On Off On COM4 (2E8h) On On Off On INTERRUPT SELECTION Setting JP1 JP2 3 Pins 1 & 2 closed N/A 4 N/A Pins 2 & 3 closed 5 N/A Pins 1 & 2 closed 9 Pins 2 & 3 closed N/A SUPPORTED COMMAND SET Basic AT Commands AT, ‘+++’, ‘Comma’, A/ A, B, E, H, L, M, O, Q, S, V, W, X, Z &C, &D, &F, &K, &P, &S, &T, &U, &V Extended AT Commands %L, %Q S Registers S0, S1, S2, S3, S4, S5, S6, S7, S8, S9, S10, S11, S12, S18, S25, S26, S36, S37, S48 Note: Please see MHI Help file for full command documentation. Proprietary AT Command Set AUTO-RETRAIN Type: Configuration Format: AT [cmds] %En [cmds] Description: Controls auto-retrain mode Command Function %E0 Auto-retrain disabled %E1 Auto-retrain enabled CONNECT MODE Type: Configuration Format: AT [cmds] \Nn [cmds] Description: Controls the type of connection the modem will operate in Command Function \N0 Normal mode enabled \N1 Direct mode enabled \N2 Reliable MNP4 mode enabled \N3 Auto-reliable MNP4 mode enabled \N4 Reliable V.42 mode enabled \N5 Auto-reliable V.42 mode enabled DIAL Type: Immediate Format: AT [cmds] D<#> [cmds] Description: Dials telephone number according to any modifiers included in the string Note: Any combination of modifiers can be used to produce the desired dial functions in sequence. Modifier Function P Pulse dialing enabled R Answer mode enabled, originate mode disabled following handshake initiation T Tone dialing enabled W Dialing resumed following dial tone detection , Dialing paused for amount of time specified in S8 register @ Wait for 5 seconds of silence ; Modem returned to command state after dialing ! Modem commanded to go off-hook for half a second REPORT INFORMATION Type: Immediate Format: AT [cmds] In [cmds] Description: Displays information requested Command Function I0 Reports product code I1 Reports firmware ROM checksum number I2 Tests and reports ROM checksum, ‘OK’ or ‘ERROR’ I3 Reports /