ACS COMPUTER GROUP LASERWAVE FUTURA 16 Card Type Sound card Chipset Controller Unidentified I/O Options CD-ROM audio (2), CD-ROM interface (3), daughter board interface, game/MIDI port, line in, line out, microphone in, speaker out, wavetable connector Maximum DRAM N/A [Image] CONNECTIONS Purpose Location Purpose Location Game/MIDI port CN1 Sony CD - audio CN7 in Sony CD-ROM interface CN2 Panasonic CD - CN8 (SCSI extension audio in interface) Mitsumi CD-ROM CN3 Speaker out J1 interface Panasonic CD-ROM CN4 Line out J2 interface Wavetable connector CN5 Line in J3 Daughter board CN6 Mic in J4 interface (3D space processor) MICROPHONE SELECTION Setting JP8 JP9 » All microphone/Electric Closed Closed condenser active Dynamic microphone active only Open Open WINDOWS SOUND SYSTEM MODE I/O PORT ADDRESS SELECTION Address SEL0 SEL1 » 530h Closed Closed 604h Open Closed E80h Closed Open F40h Open Open GAME PORT CONFIGURATION Setting JP11/A » Enabled Open Disabled Closed SOUND BLASTER PRO I/O PORT ADDRESS SELECTION Address JP11/B JP11/C » 220h Open Closed 240h Closed Open 260h Open Open Disabled Closed Closed MPU-401 MIDI PORT CONFIGURATION Setting JP11/D » Enabled Open Disabled Closed MPU-401 MIDI PORT I/O ADDRESS SELECTION Address JP11/E » 330h - 331h Open 320h - 321h Closed GAME PORT I/O ADDRESS SELECTION Address JP11/F » 201h Open 200h - 207h Closed CD-ROM SELECTION Setting JP7 » Panasonic AT-bus Closed Sony, Mitsumi, or SCSI bus Open CD-ROM I/O PORT ADDRESS SELECTION Address JP10 » 340h Open 320h Closed SCSI CD-ROM INTERRUPT SELECTION IRQ JP4 JP5 JP6 » Disabled Open Open Open 5 Open Open Closed 12 Open Closed Open 15 Closed Open Open MPU-401 MIDI PORT INTERRUPT SELECTION IRQ JP1 JP2 JP3 » 9 Closed Open Open 5 Open Open Closed 7 Open Closed Open Disabled Open Open Open 3D SPACE PROCESSOR INTERFACE CONFIGURATION Setting CN6/A CN6/B CN6/C CN6/D CN6/E CN6/F » Not Closed Closed Open Closed Closed Open attached Attached Open Open Open Open Open Open Note: If daughter board is not attached add jumpers to the interface so sound board can operate. If daughter board is attached remove all jumpers from interface before connecting.