SEANIX TECHNOLOGY, INC.

ASI-WINJET (VER. 1.0)

Category                    Video
Video Types Supported       XVGA
Video Processor             Western Digital WD90C31A
Highest Resolution          1280 x 1024
Supported
Data Bus Type               16-bit ISA
Memory Type                 DRAM
Maximum Onboard Memory      1MB

[Image]

                                CONNECTIONS

      Purpose          Location            Purpose            Location

  Video out               J1          VGA feature                JP3
                                      connector

                 VERTICAL RETRACE SELECTION FOR 800 X 600

           Rate                     SW1/1                   SW1/2

  »          56Hz                    Off                     Off

             56Hz                     On                      On

             60Hz                    Off                      On

             72Hz                     On                     Off

                 VERTICAL RETRACE SELECTION FOR 1024 X 768

               Rate                       SW1/3               SW1/4

  »           Interlaced                   Off                 Off

              Interlaced                   On                  On

         60Hz non-interlaced               Off                 On

         70Hz non-interlaced               On                  Off

                       HORIZONTAL RETRACE SELECTION

                  Rate                                 JP1

  »               31.5KHz                        Pins 3 & 4 open

                   40KHz                        Pins 3 & 4 closed

                         WAIT STATE CONFIGURATION

              Wait States                              JP2

  »                  0                               Closed

                    >0                                Open

                        ADDRESS LATCH CONFIGURATION

                 Setting                                JP6

  »           Non-80286 systems                  Pins 1 & 2 closed

                80286 systems                    Pins 2 & 3 closed

  FACTORY CONFIGURED - DO NOT ALTER

      Jumper             Setting

        JP5               Open

  JP1 pins 1 & 2          Open