DANPEX CORPORATION AN-500T/AN-202T/AN-808T/AN-202L NIC Type ARCnet Transfer Rate 2.5Mbps Data Bus 16-bit ISA Topology Linear Bus Star Wiring Type Unshielded twisted pair Boot ROM Available [Image] BASE MEMORY ADDRESS SELECT Address SW1/7 SW1/8 SW1/9 SW1/10 » D0000h - D07FFh Off Off On Off C0000h - C07FFh Off Off On On E0000h - E07FFh Off Off Off On INTERRUPT SELECT IRQ JP8 JP9 JP10 JP11 JP12 JP13 » IRQ9/2 Open Open Open Open Open Closed IRQ3 Closed Open Open Open Open Open IRQ4 Open Closed Open Open Open Open IRQ5 Open Open Closed Open Open Open IRQ6 Open Open Open Closed Open Open IRQ7 Open Open Open Open Closed Open INTERRUPT SELECT (CONTINUED) IRQ JP3 JP4 JP5 JP6 JP7 IRQ14 Closed Open Open Open Open IRQ15 Open Closed Open Open Open IRQ12 Open Open Closed Open Open IRQ11 Open Open Open Closed Open IRQ10 Open Open Open Open Closed I/O ADDRESS SELECT Address SW1/1 SW1/2 SW1/3 SW1/4 SW1/5 SW1/6 » 2E0h Off On Off Off Off On 2F0h Off On Off Off Off Off 300h Off Off On On On On NODE ADDRESS Node SW2/1 SW2/2 SW2/3 SW2/4 SW2/5 SW2/6 SW2/7 SW2/8 0 - - - - - - - - 1 On On On On On On On Off 2 On On On On On On Off On 3 On On On On On On Off Off 4 On On On On On Off On On 251 Off Off Off Off Off On Off Off 252 Off Off Off Off Off Off On On 253 Off Off Off Off Off Off On Off 254 Off Off Off Off Off Off Off On 255 Off Off Off Off Off Off Off Off Note:Node address 0 is used for messaging between nodes and must not be used. A total of 255 node address settings are available. The switches are a binary representation of the decimal node addresses. Switch 8 is the Least Significant Bit and switch 1 is the Most Significant Bit. The switches have the following decimal values: switch 1=128, 2=64, 3=32, 4=16, 5=8, 6=4, 7=2, 8=1. Turn Off the switches and add the values of the Off switches to obtain the correct node address. (On=0, Off=1) RESPONSE AND RECONFIGURATION TIMEOUTS Reconfiguration Time IDL Time ( Response Time JP1 JP2 m ( m » 840ms 86 78 Open Open 1.68 sec 316 285 Closed Open 1.68 sec 624 563 Open Closed 1.68 sec 1237 1130 Closed Closed TERMINATOR SELECT Setting JP14 Card used at end of Linear Bus Closed Card not used at end of Linear Bus Open DIAGNOSTIC LED Color Status Condition Green On PC is on Green Blinking Data is being transmitted/received FACTORY CONFIGURED SETTINGS Jumper Setting JP15 Closed