RACAL INTERLAN, INC.

NI6210-10BT (VERSION 2)

NIC Type      Ethernet
Transfer Rate 10Mbps
Data Bus      16-bit ISA
Topology      Linear bus
Wiring Type   Unshielded twisted pair

              AUI transceiver via DB-15
Boot ROM      Available

[Image]

                   BASE I/O ADDRESS

  Address     JP1A       JP1B      JP1C       JP1D

   300h      Closed      Open      Open       Open

   320h       Open      Closed     Open       Open

   340h       Open       Open     Closed      Open

   360h       Open       Open      Open      Closed

                             BOOT ROM ADDRESS

   Address       JP2A        JP2B        JP2C        JP2D         JP2E

   D0000h       Closed       Open        Open        Open         Open

   D4000h        Open       Closed       Open        Open         Open

   D8000h        Open        Open       Closed       Open         Open

   DC000h        Open        Open        Open       Closed        Open

   No Boot       Open        Open        Open        Open        Closed
     ROM

                     DMA CHANNEL

  Channel     JP3A       JP3B      JP3C       JP3D

   DMA0      Closed      Open      Open       Open

   DMA3       Open      Closed     Open       Open

   DMA5       Open       Open     Closed      Open

   DMA6       Open       Open      Open      Closed

               INTERRUPT SETTINGS

   IRQ      JP4A      JP4B      JP4C      JP4D

   2/9     Closed     Open      Open      Open

    5       Open      Open      Open     Closed

    12      Open     Closed     Open      Open

    15      Open      Open     Closed     Open

                             CABLE TYPE

               Type                              SW1

     Unshielded twisted pair                 Position B

  AUI transceiver via DB-15 port             Position A

                              LINK INTEGRITY

                Function                                W18

  »         Link intergity enabled               Pins 1 & 2 closed

           Link integrity disabled               Pins 2 & 3 closed

  Note: If card is used in a pre-10BaseT cabling network, disable the
  link integrity function.

                         DIAGNOSTIC LED(S)

    LED                           Condition

     On                     Link integrity exists

    Off                 Link integrity does not exist

  Note:LED is active only when NIC is used in a 10BaseT network.